User Profile
Collapse
-
No doubt- this is not the easy way to do it, and I am apt to go off the rails during the development of ideas. It is fun for me to do this stuff-
-
👍 1
-
-
I'm sure the ongoing costs of this will be noted and weighed appropriately. It will be some work for me to put it together in the first place. I know...
Leave a comment:
-
-
I'd like to see the heat treat process for something of that size-
Leave a comment:
-
-
Hm, lots of responses. Let me clear up some questions. First, yes, the plan is to draw the separate components into their separate cups by using vacuum....Last edited by darryl; 04-14-2024, 01:24 AM.
-
👍 1
Leave a comment:
-
-
I have previously made two domed lexan covers- both are for a combined pressure and vacuum vessel. Neither one is the right size for this, otherwise I'd...
Leave a comment:
-
-
-
vacuum vessel window
Sounds like a name for a band. You heard it here first-
I have a sturdy stainless bowl that I'm about to turn into a vacuum vessel to help...
-
-
Good topic- many of us home machinists could potentially cast parts for themselves, and fit it within the budget. I'm sure there are primer courses out...
Leave a comment:
-
-
Ok- I can see the slow speed at first to get it cleaned up. But then crank that baby up to 3000 rpm
-
😀 3
Leave a comment:
-
-
It's interesting, and I think it's valid- there is enough 'home made' on that to qualify.
One thing that always seems to come up for me...
Leave a comment:
-
-
It's a flux ring. Many motors have that.
When I re-built my Unimat motor, I used permanent magnets instead of the wound field. The only...
-
👍 2
Leave a comment:
-
-
Just to share what I've done- I'd drip a little CA where I want the cut to be, then wrap some thread around for about a half inch either side of the cut....
Leave a comment:
-
-
I could waste $30 or $50 of my time easily if I were trying to make one. And it would likely be for a one-use- and probably not as accurately made as...
Leave a comment:
-
-
I think we'll always have people on both sides- the majority being interested in a persons efforts, and wanting to help if they can. The less being the...
Leave a comment:
-
-
Gettin creative with the lathe. Those look cool- bit of an optical delusion. That would be a fun project in brass, done on a Unimat- or done in cast plastic...
Leave a comment:
-
-
There was a time when I would go to a car wash and blast the alternator brush area with the wand. I always made sure the engine was warm, and blasted...
Leave a comment:
-
-
It's a lot of glams- just like the number of thousandths in an inch- must be a million of 'em....
Leave a comment:
-
-
At least some of those 6A diodes are Shottky types- meaning they have a lower voltage drop than regular diodes. If 1 amp is going to be flowing continuously,...
Leave a comment:
-
-
-
I was under the impression that pressures are likely to be around 7.5 ksi in bottle jacks. An interesting 'aside' is the difference between one of my...
Leave a comment:
-
No activity results to display
Show More
Leave a comment: