Don't recall if this has been up on the board recently...
Any known cure for an unevenly worn three-jaw lathe chuck scroll?
(I imagine this is the case. Chuck is ancient. Cleaned, relubed, scraped, shimmed, remounted, jaws ground internally to niiice TIR at one particular diameter. Any other diameter is totally all over the place. By a LOT- like +/- a millimeter or two or more.)
Wait a sec- Just remembered, wasn't there an article in HSM about this? Forrest, was that you?
Any known cure for an unevenly worn three-jaw lathe chuck scroll?
(I imagine this is the case. Chuck is ancient. Cleaned, relubed, scraped, shimmed, remounted, jaws ground internally to niiice TIR at one particular diameter. Any other diameter is totally all over the place. By a LOT- like +/- a millimeter or two or more.)
Wait a sec- Just remembered, wasn't there an article in HSM about this? Forrest, was that you?
Comment