PDA

View Full Version : Photo: Interesting Headstock Center



Carl
02-13-2005, 11:12 PM
http://img.photobucket.com/albums/v35/lathefan/fc75d859.jpg

precisionworks
02-13-2005, 11:19 PM
Where do you find these great old pics?

x39
02-13-2005, 11:44 PM
Good grief, look at the size of the counter weights they're running on the face plate! I wonder what they were turning.

Doc Nickel
02-14-2005, 03:51 PM
I love that all-gear-drive tailstock!

But any idea what that handwheel/bevelgear is for, on the side of the apron where a threading dial would usually go?

Doc.

John Stevenson
02-14-2005, 04:11 PM
Looks as if it turns the bottom shaft thru a bevel.
Could it be the clutch ?

jburstein
02-14-2005, 04:11 PM
this was posted on the other forum:

"from the looks of it, the lathe has a D.C. Drive motor- not uncommon in the older shops. The older DC Motors used to use a kind of drum controller- sometimes referred to as a "Trolley Car" controller. This was to give a soft start and vary the speed. The handwheel to the RH of the carriage may well be for working the drum control switch to start/stop and vary the speed of the spindle.

Joe Michaels"

Gary Helmick
02-14-2005, 04:25 PM
It's used to advance the tailstock.
Gary Helmick

Gary Helmick
02-14-2005, 04:27 PM
My bad I was looking at the wrong wheel.
Gary Helmick

motorworks
02-14-2005, 04:39 PM
Had a request today to make these large vee pullies.
I could have used a machine like this!!
eddie
ps Still think the coffee table book would work!!

John Foster
02-14-2005, 04:57 PM
Look at how small the crossfeed dial appears. Is it possible they didn't even have one? Nice picture.

Spin Doctor
02-14-2005, 09:29 PM
From the counterweights they had to be turning some kind of ecentric. Most likely a crankshaft of some sort. And that center looks like something Wonder Woman could use http://bbs.homeshopmachinist.net//wink.gif