PDA

View Full Version : Got some DC motors... feed ideas?



hoffman
03-29-2005, 09:09 PM
2 DC wheelchair motors with gear boxes . I have a Dart motor controller I got a few months ago. One is gonna be for the power quill feed on the Gorton. The Gorton quill feed is a lot like a mill/drill so anyone have some ideas with pics?
I also have an extra table feed that I was thinking about using.
Lotsa clever folks here...

------------------
Hoffman in Warner Robins Ga

[This message has been edited by hoffman (edited 03-29-2005).]

charlie coghill
03-29-2005, 09:23 PM
If you could post a pic of them maybe I could offer some suggestions.
Charlie

hoffman
03-30-2005, 10:01 PM
24 volt motors... Not sure if my controller will do it...
Controller is a dart 125.

------------------
Hoffman in Warner Robins Ga

[This message has been edited by hoffman (edited 03-30-2005).]