PDA

View Full Version : Halfnuts - Identify?



CCWKen
08-19-2005, 08:18 PM
Anyone know what these halfnuts might go to? They are Large!

http://img.photobucket.com/albums/0903/CCWKen/Loads/Halfnuts03.jpg

http://img.photobucket.com/albums/0903/CCWKen/Loads/Halfnuts04.jpg

BillH
08-19-2005, 08:48 PM
Hmm, I dont know, IOWolf seams a half nut short http://bbs.homeshopmachinist.net//biggrin.gif

rockrat
08-19-2005, 09:37 PM
Oh no, here we go. http://bbs.homeshopmachinist.net//biggrin.gif http://bbs.homeshopmachinist.net//biggrin.gif http://bbs.homeshopmachinist.net//biggrin.gif

PolskiFran
08-19-2005, 09:47 PM
What size is the lead screw that it would fit? What are the casting marks? My Nebel lathe has large half nuts and very large half nut operating lever.

Frank

[This message has been edited by PolskiFran (edited 08-19-2005).]

CCWKen
08-19-2005, 10:02 PM
I think these are 1" 6tpi but I'm not for sure. I'll have to get the dimensions and marks tomorrow. What casting marks there are, are shown in the first picture. I just can't make them out now either. They're NOS but don't fit anything I have.

beckley23
08-19-2005, 10:08 PM
I think they are South Bend, most likely a 16".
Harry