PDA

View Full Version : Balancing engines



docsteve66
10-31-2002, 05:45 PM
Here is a link for anyone wanting to balance things. They have a chart showing how much weight drills remove for various sizes and epths of drill and how much to adjust for drill point. They give a few formula for calculating unbalance effects at different RPM. They are mainly concerned with automobile engines, fly wheels cranks, cams, high preformance.
Usual disclaimer- I have no involvment in any way with them.
Steve

3jaw
10-31-2002, 06:45 PM
Uhhhhhhhhhhhhh, where's da link? http://bbs.homeshopmachinist.net//biggrin.gif

docsteve66
10-31-2002, 07:12 PM
3jaw: did your mother not tell you to point out a mans error sublety? You could have just said the link did not work and cuss Microsoft. http://bbs.homeshopmachinist.net//smile.gif For htose who did not get the link the first time i didnt post it:

http://www.ghbalancer.com/pages/techinfo.htm

Steve

Thrud
11-02-2002, 01:12 AM
Steve
I can blame Evil Bill for 9/11, I can blame Evil Bill for lousy chocolate milk, but I cannot blame him for 3Jaw pointing out that you suffer from "fast fphat phinger desease" or the "me first syndrome" - you show off! http://bbs.homeshopmachinist.net//biggrin.gif

docsteve66
11-02-2002, 09:19 AM
Its "finger stutter" that I suffer from.
Steve

3jaw
11-02-2002, 07:16 PM
Steve,

If it makes you feel any better, I pushed a door that was marked "Pull" one time. http://bbs.homeshopmachinist.net//smile.gif

Greg

Thrud
11-02-2002, 10:33 PM
3jaw:
I still do that - I feel like a far side cartoon. http://bbs.homeshopmachinist.net//biggrin.gif

docsteve66
11-03-2002, 04:53 PM
I flunk doors most every day. di it just a few hours ago
Steve