View Full Version : Another jet question

Ron LaDow
04-22-2001, 09:11 PM
I have a Jet 10-24 lathe that was used when I bought it 20 years ago. (Doug, works fine).
I'd like a 4-jaw chuck to fit, but the spindle is 2"-8TPI.
Are such chucks available, or do I need to machine a back plate to fit?

04-23-2001, 06:25 PM
I'm not sure. you might try jlindustrial.com.
Also enco. if it's standard there should be

Ron LaDow
04-23-2001, 08:55 PM
Thanks. Tried today. It's either from Jet or machine a plate.
Not bad, though, that Jet still supports a 20-year old machine. And it was cheaper than the chuck and the plate.