PDA

View Full Version : FS/FT: Powermatic Millrite 8x36 table 1HP 3 PH R8



ChrisAttebery
09-21-2004, 12:16 PM
Hello,

I have a 1974 Burke Millrite that I would like to sell or trade for a dovetail column mill/drill. I bought it from the original owner. He used it in a home shop and it was barely used. The machine is in good condition, with some minor surface rust on the table and handles. The ways are in perfect condition. I have a box of R8 tooling with it and a cheap 4" vice. I'd just like to get what I paid out of it, $1500. I also have a Baldor VFD that I'd sell with it, $125.

The ONLY reason I'm selling it is that it is way bigger than I need for my modeling. It's not quite going to fit where I want it and I
really don't need a 36" table. Most of my projects will fit in the palm of your hand.

I'm located in Gilroy, CA just south of San Jose.

Please send me an email if you are interested. I don't check these groups very often.

Thanks,


Chris