PDA

View Full Version : NIMS Standards



spope14
12-19-2001, 09:53 AM
I am currently in the process of certifying my machining program to meet the NIMS (National Metalworking Standards Institute) standards for machining in level one and level two. I have heard quite a bit of good about these standards, and am in fact taking the tests themselves to how I know what is expected and can do my job. What I am looking fior is nyone else hom knows about the NIMS programs so I may share some feedback from others to my program advisory committee. Feedback that is not "canned" by Nims, feedback from individuals. Hope there are bites on this one.

bdarin
12-19-2001, 10:35 PM
Sorry, spope, this is not a bite, but I would like to learn more about these standards. Where can I get info? TIA, Bob