View Full Version : bench master mh2 mill

02-16-2008, 04:33 PM
anyone have or had one that would like to share some input?am thinking about one i can pick up for $425.right now i use a sherline and it is kind of a pain but i've made do with it quite nicely.

02-16-2008, 05:53 PM
I had one with a vertical head, and it was a very good little machine. The only drawback was the lack of a moveable spindle.

I don't know what the MH 2 designation is. They were available in horizontal and vertical configurations. Either is a good machine. They are real tools, cst iron construction etc.

Al Messer
02-16-2008, 05:57 PM
Check it out on the www.lathes.co.uk/index site.

02-16-2008, 06:12 PM
ok this is the info i know havrn't seen it yet. ser# 7329 model mh2 and it has a 6x18 table.what about the price, fair or not depending on condition?