good afternoon.
i bought this [new to me] Cincinnati Toolmaster mill last week. mill ran fine. no problems.
yesterday i was milling away and it stopped. i shut everything down and checked power from service entrance forward. no problems until i got to the switch on top that turns it off and on and reverses it. i found some loose connections there. put it all back together and mill ran, but sometimes i would have to jiggle the switch to make it start.
this morning it stopped again. same deal. motor hums but doesn't start. switch jiggling is not effective.
i would appreciate anyone who could offer any insight on this problem doing so. it looks like an expensive switch to me.
thanks and happy weekend.
bill
i bought this [new to me] Cincinnati Toolmaster mill last week. mill ran fine. no problems.
yesterday i was milling away and it stopped. i shut everything down and checked power from service entrance forward. no problems until i got to the switch on top that turns it off and on and reverses it. i found some loose connections there. put it all back together and mill ran, but sometimes i would have to jiggle the switch to make it start.
this morning it stopped again. same deal. motor hums but doesn't start. switch jiggling is not effective.
i would appreciate anyone who could offer any insight on this problem doing so. it looks like an expensive switch to me.
thanks and happy weekend.
bill
Comment