PDA

View Full Version : Compucut?



CompositeEngr
02-09-2002, 07:04 PM
I'm rather new to machining in general, and thinking about setting up a small shop for misc. parts.
Is anyone experienced with the Compucut system?
Any other comments or suggestion are also welcome.

Thanks

dmcdonald
02-11-2002, 10:24 AM
I have the compucut kit from Britain, but have not started building yet. Still trying to figure out the kit and instructions. Lots of language challenges (pillar drill for drill press, etc) and assumptions that the reader knows a lot more than I do. Seems like a worthwhile venture however, and I intend to proceed with it.