I picked up a lot of unfinished (spin type) aluminum handles at a local flea market. I was planing on upgrading some of the smaller spin handles on my cheap import equipment, problem is I dont have a completed one to go by and I
looking for ideas as to how they need to be finished so they will spin freely
with a stud mounted in it.
Handle outsides are finished and have a central 3/8" hole 2" deep with a set
screw in the outer rim, would make great tool handles as is but I need ones that spin.
looking for ideas as to how they need to be finished so they will spin freely
with a stud mounted in it.
Handle outsides are finished and have a central 3/8" hole 2" deep with a set
screw in the outer rim, would make great tool handles as is but I need ones that spin.