I built a roll-on motorcycle lift from a old engine stand and long ram cherry picker jack. It works great but is about 10 feet long when on floor. I wish I had a plan instead of just try-it type engineering.
Lots of smart guys on here.. SHould Neil make a site to post plans on?
The polisher-grinder I saw from a very old post has my attention too. I am sure I can't find a 82 copy of HSM thou. Some good ones might even make it into HSM?
No how-to's plans with directions here, just hand drawings of measurements. They are scattered to the 4 winds, several note books.
Lots of smart guys on here.. SHould Neil make a site to post plans on?
The polisher-grinder I saw from a very old post has my attention too. I am sure I can't find a 82 copy of HSM thou. Some good ones might even make it into HSM?
No how-to's plans with directions here, just hand drawings of measurements. They are scattered to the 4 winds, several note books.