It's SB9 time again

[shaque]

Hi again folks, hope you merican cousins dint eat too much turkey anyway I have had a chip tray made for my SB9 model "C" 3 foot, now I want to drill the holes in the tray for the lathe feet. I know I can take the dimensions off of the lathe itself, but it seems to me that at one time I seen these dinensions someplace, and as the lathe is still bolted in place I'd like to drill the holes befor hand. As you know, any help will be appreciated. Jim

[docsteve66]

Can't help you with numbers, but a "slide in tray" would be easy to clean.

(besides this forwards you)
Steve

[Herb W]

Shaque,
On my 9C the mounting bolts are out in the open...so I'm thinking that yours must be different.(?)

[SGW]

I think I'd be inclined to measure them, anyway. Who knows...South Bend may have changed their mind several times on hole spacing over the years.