I asked my friend Nick how he checked his tool height. He sent me a picture of a holder for a DI.
So because when I grow up I want to be just like Nick I built one for myself.
I took a very heavy piece of steel that I squared up and put a vitical rod bla bla bla.
I put an 8mm ground rod in the chuck and then adjusted the DI so the needle would zero when the plunger was moved up 1 mm.
So because I have the Multifix tool post it is a simple matter to raise the tool holder until the tip of the tool raises the plunger on the DI one mm.
How do you all do it?
So because when I grow up I want to be just like Nick I built one for myself.
I took a very heavy piece of steel that I squared up and put a vitical rod bla bla bla.
I put an 8mm ground rod in the chuck and then adjusted the DI so the needle would zero when the plunger was moved up 1 mm.
So because I have the Multifix tool post it is a simple matter to raise the tool holder until the tip of the tool raises the plunger on the DI one mm.
How do you all do it?
Comment