The original table power feed on my 2 hp bridgeport was DOA. Everything I read about it suggests it would be an expensive and/or time consuming fix. It looks like this:
I purchased a cheapo import servo power feed. It claims it fits all bridgeports and many others. It's similar to this:
Upon receiving the device, I think I don't have enough parts. The instructions are pretty unclear/obtuse. It physically fits where the old one comes off, but has no "intermediate shaft" to get from the bevel drive gear to the end of the table drive screw. I need a shaft extension of some sort to make this work.
Can I purchase this separately? Is there a kit? Recommendations?
Thanks in advance,
troy
I purchased a cheapo import servo power feed. It claims it fits all bridgeports and many others. It's similar to this:
Upon receiving the device, I think I don't have enough parts. The instructions are pretty unclear/obtuse. It physically fits where the old one comes off, but has no "intermediate shaft" to get from the bevel drive gear to the end of the table drive screw. I need a shaft extension of some sort to make this work.
Can I purchase this separately? Is there a kit? Recommendations?
Thanks in advance,
troy
Comment