PDA

View Full Version : Telescopic Gage Question ???



JoeLee
02-02-2012, 05:25 PM
I have a 3" telescopic gage that was getting a little sticky.... due to oil drying out. So.......... you guessed it I took it apart and stuff went flying. Well it happened on my bench and the explosion was contained. I put it all back to gather and then later found a small spring about .188 in dia x about .250 in length. My guess of where it went was between the handel where it screws to the top of the plunger housing to load the small locking pin against the slots in the plungers.
I can't find an exploded view of one of these and would imagine they are all the same regardless of the mfg. Any one have an idea if I'm wright.

JL....................