PDA

View Full Version : Advice for Mach-3 upgrade



hoof
04-10-2012, 08:58 AM
Hello, was wondering if any of you have converted and Yasnak MX3 controlers to the Mach three controls. If so what was that experience like. Any feedback or pointers in the right direction would be greatly appeciated. I don't even know where to begin looking for a project like this.

Ray

macona
04-23-2012, 07:00 AM
Its going to be a major project. The machine will have analog drives A kflop can do that with the analog board if it has encoder feedback from the axes.