I've always had my R8 collets on a rack attached to the side of my mill. It was a nice holder, just not in a handy position. Plus I have a few collets that I only use for certain things like my Herman Schmidt edge finder and the rack couldn't turn if a collet has something in.
Anyway, I made up these additions. I keep my roll around to the rear right of me when I'm at the mill, so these keep the collets close at hand.
1.5 x 1.5 aluminum and 1.0 dia aluminum standoffs.
Anyway, I made up these additions. I keep my roll around to the rear right of me when I'm at the mill, so these keep the collets close at hand.
1.5 x 1.5 aluminum and 1.0 dia aluminum standoffs.
Comment