View Full Version : 3/32 square collet and holder

12-31-2013, 09:48 PM
I am looking for a 3/32 square collet and holder for a dual angle engraving tool sharpener I am building. It would be about the size a Dremel tool uses altho they don't make a square collet as far as I know. Any ideas where I might start looking, google has been no help so far. I thought a jewelery store supply has came to mind but no luck so far. I need to be able to index it the same each time the tool is removed and installed. This is similar to the one I am working on