As I said, I am not trying to repair it as I already have a working replacement. Just seeking knowledge. After 45+ years of servicing electronics, I...
It was the fan attached to a heat sync that was attached to the CPU via a copper tube. Probably a heat pipe of some kind. I guess it also cooled the...
I'm not familiar with the Wade 8A lathe, but this attachment seems like a lot of work to avoid purchasing or making a metric transition gear set. For...
Screws for holding the heat shield in place? Yes, almost anything, including most plastics if you are worried about the screws transmitting the heat....
OK, I just looked up "Peltier". This is a device that uses the flow of current between two different conductors to induce the transfer of heat across...
You show a picture of a device with a bunch of heat sync fins. These fins work by having air flow across them. The heat from the device goes into the...
In a small shop you may need to use the same circuit for both three phase and single phase devices. The RPC switch would allow you to turn the third...
I played with this idea a bit using my CAD program. One of my questions was just how many teeth could you produce on a cutter using this technique. I...
If this is a one time situation, there are places that rent video equipment. HD cameras, recorders, features like controllable shutter speed to help...
I would not ever make a part where the print or the buyer says it is a "Xxxxx" for motorcycle or a car or truck or a medical device, etc. Or where I...
Find latest posts