My friend smeared a couple of big end shells on the journals on his turbo bike and it looked quite bad but I polished it with 1500 emery and wd40 and...
I always remove the guides to track the blades on the wheels, the re-fit the guides and adjust to make it cut true. Taht said - i never had much fun...
It's the field hum that I initially noticed but it's not intrusive with no load - I've heard louder refrigerators. When I spin up the motor and put a...
I got rid of runout by tilting the head of my mill to the R8 angle and set it with a dial gauge on the taper whilst lifting the knee Clamped a 4-way...
I followed the original photos and then turned mine down on the screw and bored the nut to suit. Fixed it with 2 pins and it's been working for more...
Drive is a Parker 512c. It does not offer any braking or reversing hence the circuitry. Rob's 514c does all that onboard but is four times the cost....
I'm just rigging up some contactors for mechanical fwd/rev for my lathe and I need some help designing a suitable circuit.
In the attached diagram I...
Find latest posts