• OKChipmaker's Avatar
    06-03-2018, 10:30 PM
    I think you ended up with chilled cast iron. This is some times done to get a hard surface. A piece of metal is inbeded in the sand mold to remove...
    36 replies | 2300 view(s)
  • OKChipmaker's Avatar
    06-02-2018, 09:15 PM
    Just in case the heat does not work. I seem to remember reading that early auto engines with cast iron pistons had a coating of tin put on, may be...
    36 replies | 2300 view(s)
  • OKChipmaker's Avatar
    03-25-2018, 02:39 PM
    OKChipmaker replied to a thread Unknown KD tool? in General
    used to install new valve guides in cly. heads. When placed over the new guide it limited the proper depth it was to be installed.At least that was...
    29 replies | 2407 view(s)
No More Results
About OKChipmaker

Basic Information

Statistics


Total Posts
Total Posts
157
Posts Per Day
0.04
General Information
Last Activity
Today 01:56 PM
Join Date
08-03-2008
Referrals
0