Register
Help
Remember Me?
What's New?
Forum
New Posts
FAQ
Calendar
Community
Groups
Albums
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
Advanced Search
easymike29
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
easymike29
Member
Find latest posts
Find latest started threads
Mini Statistics
Join Date
09-09-2008
Last Activity
Today
08:58 PM
Tab Content
easymike29's Activity
About Me
Tab Content
All
easymike29
Friends
Photos
New Activity (
)
Older Activity
05-10-2013,
03:22 PM
easymike29
replied to a thread
Help needed in design of a pin cutoff machine
in
General
Tip: The moveable wheel must be "canted" a couple of degrees to cause the part to move in the direction of the stop. I cannot remember which way it...
see more
20 replies | 1111 view(s)
05-10-2013,
12:25 PM
easymike29
replied to a thread
Help needed in design of a pin cutoff machine
in
General
You might be interested in this concept. http://www.asmfab.com/Spin-Rolls.aspx Gene
see more
20 replies | 1111 view(s)
04-30-2013,
10:44 AM
easymike29
replied to a thread
New to CNC plasma, help with draftsight software and plasmacam software please. :)
in
Digital Machinist
I have a stencil font which will work in Draftsight but I'm not permitted to attach it. PM me if you want it. Gene
see more
18 replies | 773 view(s)
04-28-2013,
02:08 PM
easymike29
replied to a thread
how would you make these?
in
General
If I were grinding that part I would start with rectangular blanks long enough for about 10 pieces at a time. Next would be heat treat and grind all...
see more
27 replies | 2039 view(s)
04-28-2013,
11:39 AM
easymike29
replied to a thread
New to CNC plasma, help with draftsight software and plasmacam software please. :)
in
Digital Machinist
Sent you a PM Gene
see more
18 replies | 773 view(s)
04-27-2013,
02:57 PM
easymike29
replied to a thread
New to CNC plasma, help with draftsight software and plasmacam software please. :)
in
Digital Machinist
Are you familiar with the Command Line? Gene
see more
18 replies | 773 view(s)
More Activity
No More Results
About easymike29
Basic Information
About easymike29
Location:
San Diego
Occupation:
Retired metalworker
Statistics
Total Posts
Total Posts
95
Posts Per Day
0.06
General Information
Last Activity
Today
08:58 PM
Join Date
09-09-2008
Referrals
0
Find latest posts