Tab Content
  • mikey553's Avatar
    11-08-2017, 04:55 PM
    mikey553 replied to a thread What lathe to buy in General
    Randy, I was in the same position as you when I bought my Grizzly G4003 lathe. That was 13 years ago. I've got my PM mill 5 years ago. Both new...
    87 replies | 5022 view(s)
  • mikey553's Avatar
    11-08-2017, 10:29 AM
    mikey553 replied to a thread Starting small. in General
    I feel like I am am in a good position to post a comment here since I have a Grizzly lathe (China) and PM vertical mill (supposedly made in Taiwan)....
    11 replies | 1006 view(s)
  • mikey553's Avatar
    10-18-2017, 09:24 PM
    mikey553 replied to a thread HF 2 Ton Shop Crane in General
    I do not have a HF engine hoist. Mine came from Sam's years ago. I believe it is much better quality than HF one. None of the load bearing screws ...
    81 replies | 5387 view(s)
  • mikey553's Avatar
    09-20-2017, 01:55 PM
    On my 12 x 36 Grizzly lathe I had the same problem and I could not adjust the bearing preload. The rear bearing inner race supposed to slide on the...
    20 replies | 2100 view(s)
No More Results
About mikey553

Basic Information

About mikey553
Location:
York, PA
Interests:
Machining, guns, gardening, optics
Occupation:
Engineer

Statistics


Total Posts
Total Posts
117
Posts Per Day
0.02
Albums
Total Albums
2
Total Photos
7
General Information
Last Activity
12-13-2017 10:20 AM
Join Date
08-16-2004
Referrals
0