Tab Content
  • Daminer's Avatar
    01-23-2016, 05:11 PM
    Back in my wrench-bending days as an A&P mechanic I remember working with a gentleman who worked on altimeters and such in WW2. Old style altimeters...
    25 replies | 1534 view(s)
  • Daminer's Avatar
    01-23-2016, 04:51 PM
    Daminer replied to a thread drilled holes out of place in General
    Amen. Even with a center drill start, a drill bit with uneven cutting edge lengths may tend to pull off center. Jim
    42 replies | 3064 view(s)
  • Daminer's Avatar
    01-15-2016, 06:06 PM
    This is strictly an off the wall idea, but perhaps the wrist pin from a large engine would be available. Check the parts store or junkyard. Jim
    35 replies | 2963 view(s)
  • Daminer's Avatar
    01-13-2016, 02:58 AM
    Daminer replied to a thread OT- LED Tubes? in General
    Replaced the two bulbs in the garage fixture with costco bulbs on sale. No ballast or starter alteration, just swapped bulbs and away we go. ...
    17 replies | 1335 view(s)
  • Daminer's Avatar
    12-27-2015, 03:21 PM
    Daminer replied to a thread HSM members occupations? in General
    Retired airline pilot/A&P mechanic/flight instructor and amateur machinist. Did steel mill electrical repair in my yout interrupted by a stint in...
    264 replies | 60217 view(s)
  • Daminer's Avatar
    12-27-2015, 02:58 PM
    Daminer replied to a thread Can't stay logged on. in General
    Same here. I log in and a bit later I get an error message and have to log in again. This started about 2 months ago. Jim
    18 replies | 899 view(s)
  • Daminer's Avatar
    12-09-2015, 02:45 PM
    Daminer replied to a thread Polishing Aluminum in Gunsmithing
    Another good product, check your local auto parts store: http://www.amazon.com/Mothers-05101-Mag-Aluminum-Polish/dp/B0009H519Y
    7 replies | 692 view(s)
  • Daminer's Avatar
    11-29-2015, 03:05 PM
    Daminer replied to a thread Work bench material... in General
    My main bench is 3 Sears 5' units joined into one surface. Knowing the thick particle board wasn't ideal, I covered it with 1/4" masonite. Screwed...
    25 replies | 2039 view(s)
No More Results
About Daminer

Basic Information

About Daminer
Biography:
retired pilot
Location:
grass valley, CA

Statistics


Total Posts
Total Posts
174
Posts Per Day
0.04
General Information
Last Activity
Yesterday 03:03 PM
Join Date
08-31-2004
Referrals
0