View Profile: velocette - The Home Shop Machinist & Machinist's Workshop Magazine's BBS

Tab Content: All; velocette; Friends; Photos

Older Activity
Yesterday, 08:33 PM

velocette replied to a thread Fact or "old wives tale"? in Home Shop Welding

No fancy theories here just cold hard facts. EDIT J Tiers thanks for a full explanation that gives us the why's and wherefores of what does...

see more

9 replies | 363 view(s)
06-16-2013, 03:36 PM

velocette replied to a thread Fact or "old wives tale"? in Home Shop Welding

Hi to quote ironmonger "The battery, if left in the circuit will absorb stray voltage spikes, which can reach 70 volts (open circuit from the welder...

see more

9 replies | 363 view(s)
06-15-2013, 04:26 PM

velocette replied to a thread Fact or "old wives tale"? in Home Shop Welding

Certainly not an old wives tales I have seen the effect on the diodes on the alternator on a truck that had extensive welding done to the body work....

see more

9 replies | 363 view(s)
04-15-2013, 05:26 PM

velocette replied to a thread Lathe speed control in General

Hi Had look at postings and lots of good advice on getting the drive ratio right. Be very Careful with any DC controller they are NOT "PLUG AND...

see more

11 replies | 993 view(s)
04-14-2013, 10:54 PM

velocette replied to a thread Lathe speed control in General

Hi Jim I see from your profile that you are in the USA so no problems with 110 volts AC supply. This is one of the controllers I use it is 220 or...

see more

11 replies | 993 view(s)
04-11-2013, 08:41 PM

velocette replied to a thread Which way angular contact bearings in pillar drill. in General

Hi dr pepper Found this on line this will link to a PDF file giving more detail on the Purchase of a Manual for your drill press See Item 3 on...

see more

19 replies | 1332 view(s)
03-29-2013, 02:16 PM

velocette replied to a thread Sieg X2 spindle alignment in General

Hi I have read this posting with great interest of the many ways to fix the problem of "Head Drop" on an X2 "Mill Drill". For what it MAY be...

see more

16 replies | 958 view(s)
03-23-2013, 06:37 PM

velocette replied to a thread benchtop bed mill headstock counterweight in General

""Is cables over the top and down the back the best method? The model I have is the G0463 I believe." The answer is YES. The counter weight needs...

see more

19 replies | 1123 view(s)

No More Results

velocette
Member

Mini Statistics

Basic Information

About velocette

Statistics

Total Posts

General Information

velocette Member

Mini Statistics

Basic Information

About velocette

Statistics

Total Posts

General Information

velocette
Member