Tab Content
  • GKman's Avatar
    04-15-2014, 07:29 AM
    I've seen an electrical panel cover with a simple lock out for generator use. The breaker that backfeeds the panel from the generator is in the...
    18 replies | 585 view(s)
  • GKman's Avatar
    04-10-2014, 07:31 PM
    Repaired a pond dam last fall. Contractor recommended moving washed out tube to a new location in virgin soil so we did. He did a thorough job...
    16 replies | 1067 view(s)
  • GKman's Avatar
    03-11-2014, 03:53 PM
    GKman replied to a thread School me on clones... in General
    I use a Lagun, made in Spain. Others here have them too. I can't imagine anything made better.
    25 replies | 1867 view(s)
  • GKman's Avatar
    03-09-2014, 09:46 AM
    GKman replied to a thread Aluminum Head Repair in General
    Plug heat dissipation? I wouldn't be concerned on one of these low performance engines but would think caution would be in order on a high...
    36 replies | 2454 view(s)
  • GKman's Avatar
    03-08-2014, 07:41 AM
    GKman replied to a thread Chisel Sharpening Fixture in General
    I'm sure cave bob knows but the previous photo of the brass wheel fixture shows an incorrect setup. The blade should be clamped in at a steeper...
    12 replies | 1112 view(s)
  • GKman's Avatar
    03-07-2014, 07:53 AM
    GKman replied to a thread Chisel Sharpening Fixture in General
    As pictured, a 1" C-clamp works good on mine. I don't call this stage sharpening, just removing metal that's in the way of sharpening. No precision...
    12 replies | 1112 view(s)
  • GKman's Avatar
    02-05-2014, 09:07 AM
    From what I have read, engineering for performance at the extreme limits of materials requires a great deal of try-fail-change-repeat. Not much fun...
    48 replies | 3578 view(s)
  • GKman's Avatar
    01-22-2014, 01:32 PM
    I didn't watch the video but I have been on one or two cruise ships sailing out of south Florida with a gyro stabilized full sized pool table. I...
    19 replies | 1567 view(s)
  • GKman's Avatar
    01-17-2014, 06:57 AM
    GKman replied to a thread dumbell in General
    Just took a load of scrap to the recycler (big old scrapyard older than I am) they wouldn't accept cast window weights - said too much lead. Anybody...
    19 replies | 1717 view(s)
No More Results
About GKman

Basic Information

About GKman
Location:
Northwest Missouri USA
Interests:
Metalworking, woodworking

Statistics


Total Posts
Total Posts
925
Posts Per Day
0.32
General Information
Last Activity
04-15-2014 07:32 AM
Join Date
04-23-2006
Referrals
0