Tab Content
  • Sun God's Avatar
    05-13-2018, 09:17 AM
    I think I'd make a silicone mold to hold the two pieces in the correct orientation, then pour a castable urethane into the remaining cavity.
    37 replies | 1646 view(s)
  • Sun God's Avatar
    05-03-2018, 04:35 AM
    Why not both? What are your workshop fire risks? Electrical (burnt out motors etc.), flammable solids (timber, plastic, paper), liquids (oil,...
    43 replies | 1989 view(s)
  • Sun God's Avatar
    05-03-2018, 01:47 AM
    Why are you changing the beds out? There's something fundamentally, conceptually wrong here. You only need one bed, whether it's heated or not. I...
    17 replies | 639 view(s)
  • Sun God's Avatar
    05-02-2018, 11:14 PM
    Why are you setting the nozzle height often enough for it to be irritating? You have a Cetus, the software retains the nozzle height offset. Unless...
    17 replies | 639 view(s)
  • Sun God's Avatar
    05-01-2018, 09:02 AM
    Sun God replied to a thread Repeatable shaft sensing in General
    Is the shaft rotating? Or just linear? Can you attach things to the end of the shaft? Shaft diameter? Doesn't sound too hard. You could probably...
    24 replies | 1036 view(s)
  • Sun God's Avatar
    03-30-2018, 02:23 AM
    Sun God replied to a thread Cetus 3d printer & ABS in General
    My Cetus was dead level straight out of the box to within a couple of thou (most of which was probably variation in the adhesive layer), no...
    19 replies | 1967 view(s)
  • Sun God's Avatar
    02-23-2018, 11:16 PM
    Simple efficiency test - weigh out 100 grams of talcum powder, suck it through your cyclone, then weigh the contents of the cyclone collector. The...
    24 replies | 2032 view(s)
  • Sun God's Avatar
    02-23-2018, 10:22 AM
    Sun God replied to a thread Steel selection advise in General
    Increasing the diameter of the handle where possible would also significantly increase is resistance to being bent, potentially moreso than...
    31 replies | 2287 view(s)
  • Sun God's Avatar
    02-23-2018, 09:50 AM
    https://www.reddit.com/r/Machinists/comments/7zkbhz/i_just_saw_a_good_machinist_of_over_40_years_lose/ I hope nobody feels condescended by this,...
    52 replies | 4527 view(s)
No More Results
About Sun God

Basic Information

About Sun God
Location:
Australia

Statistics


Total Posts
Total Posts
361
Posts Per Day
0.17
General Information
Last Activity
Yesterday 07:29 AM
Join Date
09-24-2012
Referrals
0