I use this one: http://www.use-enco.com/CGI/INSRIT?PMAKA=240-4930&PMPXNO=21108755&PARTPG=INLMK32 It is .025" thick, has a 10-14 variable pitch tooth...
The improvised choke I mentioned above in post 3 is in series with the armature. It reduced the perceived hum/buzz by 70% and had no effect on speed...
All I have to offer is that when I was trying to silence a 2HP Leeson DC motor (20A max @ 180VDC) the only thing I could find that I could afford was...
Not really. The size and scale of the two pits are vastly different, and the Kennecot site is usually relatively dry in the bottom except for spring...
Flylo, in your original post I got the impression that by 'nailed' you meant bitten but in post #9 it sounds like the dog just ran into you. Wife and...
It will attract dust. When I maintained a good-sized German made shredder, I found that the best thing to use was lightweight air-tool oil. You just...
8.8 isn't hard. It is heat treated material but is roughly equivalent to SAE grade 5. SAE grade 8 actually turns better than 5, but as mentioned you...
Find latest posts