Tab Content
  • nc5a's Avatar
    06-18-2018, 08:48 PM
    I replied on PM to your post and asked a couple questions about the rebuild but haven't seen a response yet.
    3 replies | 167 view(s)
  • nc5a's Avatar
    06-04-2018, 09:14 PM
    nc5a replied to a thread Taper pins, buy or make? in General
    I suggest you buy them. They are generally cheap to buy and if shipped USPS flat rate the cost per pin is reasonable. Shipping to Alaska is quite...
    17 replies | 869 view(s)
  • nc5a's Avatar
    06-04-2018, 01:05 PM
    nc5a replied to a thread Visiting HSM members in General
    That goes without saying..............But in order to start the ball rolling contact has to be made. I send a PM with dates I'll be in the area well...
    69 replies | 3184 view(s)
  • nc5a's Avatar
    06-04-2018, 12:35 PM
    nc5a replied to a thread Unconventional milling setup in General
    EV Nicely done and very creative, I shall remember that trick. There's always more than one way to skin a cat and this setup proves it. Nice...
    16 replies | 1100 view(s)
  • nc5a's Avatar
    06-03-2018, 01:07 AM
    nc5a replied to a thread Visiting HSM members in General
    The main issue with planning a visit of an active HSM members is determining their location as many leave their location blank. I get the privacy...
    69 replies | 3184 view(s)
  • nc5a's Avatar
    05-31-2018, 01:29 AM
    nc5a started a thread Visiting HSM members in General
    Whenever I travel I always try to visit at least one active HSM member. This time I visited BCrider and had a great time at his shop checking out his...
    69 replies | 3184 view(s)
  • nc5a's Avatar
    05-11-2018, 11:00 AM
    Nicely done Sid. The prints look to be smoother than some that I've seen, did you do any smoothing operations after printing or just trim and mount?...
    38 replies | 2076 view(s)
  • nc5a's Avatar
    04-14-2018, 02:36 AM
    Yeah, you guys are right, my title and the body of my post didn't match. Some saw through the mismatch, thanks for that and the tips for software...
    22 replies | 2088 view(s)
  • nc5a's Avatar
    04-13-2018, 08:10 PM
    I've looked at several computer design programs but haven't found one that can do what I want. I'm certain they are available, I just haven't run...
    22 replies | 2088 view(s)
No More Results
About nc5a

Basic Information

About nc5a
Location:
Alaska

Statistics


Total Posts
Total Posts
299
Posts Per Day
0.15
General Information
Last Activity
06-18-2018 08:49 PM
Join Date
01-07-2013
Referrals
0