Tab Content
  • Beone's Avatar
    04-16-2014, 10:32 AM
    Beone replied to a thread Smelters in General
    Thank You Duffy! We use melters not smelters ! Smelting is reduction from raw ore. We melt refined and/or alloyed metal to cast it. Sorry,...
    11 replies | 918 view(s)
  • Beone's Avatar
    04-08-2014, 02:32 PM
    Beone replied to a thread Bad Design ?? in General
    The blades are supposed to be loose. At speed the centrifugal force holds them tightly in place, they turn somewhere in the 15 to 30 thousand rpm...
    42 replies | 4051 view(s)
  • Beone's Avatar
    04-04-2014, 11:13 AM
    Beone replied to a thread ABS Or Delrin Sheet ???? in General
    As the two plastics are very different, I assume the material is not overly important. Consider the cutting sheet! Available many places dirt...
    19 replies | 1176 view(s)
  • Beone's Avatar
    03-25-2014, 10:25 AM
    Made 2 yesterday in 1/2-10 for my x-y table. First one made on the actual rod, second one on the end of my homemade tap from the rod, then both...
    182 replies | 161916 view(s)
  • Beone's Avatar
    02-23-2014, 11:33 AM
    Hickory NC Dave
    4 replies | 1305 view(s)
  • Beone's Avatar
    02-06-2014, 12:14 PM
    Beone started a thread Spiral point taps in General
    Been following several threads where they extoll spiral points. I tend to be a bit skeptical just got in a couple and tried them. HOLY CRAP!! No...
    8 replies | 720 view(s)
  • Beone's Avatar
    02-01-2014, 12:23 PM
    How long ago we're they cast? It can take a while for the crystal of an al casting to settle down. Solution treatment might help. Quick and...
    22 replies | 2492 view(s)
No More Results
About Beone

Basic Information

About Beone
Eastern North Carolina
Foundry, machining, cnc


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Today 07:30 PM
Join Date