Tab Content
  • MikeL46's Avatar
    02-06-2018, 11:19 AM
    I prefer the dial opposite the cutter. Then the big, clumsy hands don't get nicked by the sharp cutter while adjusting the size. Mike
    10 replies | 632 view(s)
  • MikeL46's Avatar
    01-31-2018, 12:10 PM
    Not much different than a good sized propane torch. Any tool can be misused. Mike
    6 replies | 515 view(s)
  • MikeL46's Avatar
    01-24-2018, 07:07 PM
    ????? He used a tap to make the gear. Or what were you thinking he should use the tap for? It looks like it should work for light duty. Mike
    22 replies | 1746 view(s)
  • MikeL46's Avatar
    01-18-2018, 11:26 AM
    MikeL46 replied to a thread Novice milling experiment in General
    You didn't mention any coolant/lubricant. Cutting fluids can prevent chips sticking to the cutting tool and causing what you are seeing. Mike
    34 replies | 2144 view(s)
  • MikeL46's Avatar
    01-15-2018, 09:35 PM
    MikeL46 replied to a thread RIP, Dan Gurney in General
    When I had pneumonia it was the most painful experience of my life. Worse than broken ribs/ punctured lung, worse than broken collarbone and shoulder...
    17 replies | 1466 view(s)
  • MikeL46's Avatar
    01-03-2018, 06:17 PM
    If you use an annular cutter, won't you have to mill the remaining surface to get the boss above the surface? Is that easier or quicker than drill...
    26 replies | 1698 view(s)
  • MikeL46's Avatar
    12-01-2017, 08:41 PM
    Maybe the arson was the first fire he intentionally started, not the subsequent accidental fires. The article said open fires are not allowed in the...
    42 replies | 3606 view(s)
No More Results
About MikeL46

Basic Information

About MikeL46
Biography:
Retired design engineer.
Location:
San Jose, CA:Vancouver, WA
Interests:
Airhead BMWs, Sidecars, Sportsmobiles
Occupation:
Retired

Statistics


Total Posts
Total Posts
254
Posts Per Day
0.20
General Information
Last Activity
Today 06:42 PM
Join Date
08-22-2014
Referrals
0