Tab Content
  • Captain K's Avatar
    10-23-2018, 02:05 PM
    I use an old domestic oven for preheating castings. Get it up to 450, pull out, weld, put back in oven then leave the whole thing to cool with the...
    27 replies | 1528 view(s)
  • Captain K's Avatar
    10-21-2018, 10:49 AM
    In another thread there seemed to be lots of ideas on proper bearings to use for a tool post grinder. I am leaning toward taper roller bearings,...
    34 replies | 2066 view(s)
  • Captain K's Avatar
    10-12-2018, 05:27 PM
    Captain K replied to a thread Tydeman Hone in General
    I know this is an old thread. I am having the same problem as the OP. I don't have the instruction sheet from under the lid though, so I am a little...
    4 replies | 2078 view(s)
  • Captain K's Avatar
    09-24-2018, 10:21 AM
    Captain K replied to a thread Help with motor in General
    Probably cheaper, easier and better to get a VFD, unless the motor you have is junk.
    16 replies | 1007 view(s)
  • Captain K's Avatar
    09-20-2018, 09:23 AM
    If 2 generators are hooked together they will be synchronized, there is no other possibility. The light bulbs are to synchronize them before...
    40 replies | 1873 view(s)
  • Captain K's Avatar
    08-31-2018, 03:54 PM
    I bought a mill drill that had the small step broken off by a puller. I machined it off and made a solid steel pulley with a short shaft that I...
    18 replies | 1427 view(s)
No More Results
About Captain K

Basic Information

About Captain K
Location:
SE Alberta, Canada
Interests:
Antique farm tractors, antique earthmoving equipment
Occupation:
Farmer

Statistics


Total Posts
Total Posts
79
Posts Per Day
0.07
Albums
Total Albums
1
Total Photos
1
General Information
Last Activity
Today 10:23 AM
Join Date
08-03-2015
Referrals
0