Tab Content
  • RichardG's Avatar
    Yesterday, 03:05 PM
    This is off the wall but it happens ,Do you have a chip of junk stuck in the drive gear that would account for the repeating . Put a dial indacator...
    17 replies | 959 view(s)
  • RichardG's Avatar
    03-03-2014, 08:27 PM
    RichardG replied to a thread OT Who uses a plunge saw? in General
    Any chance of finding a shop to pre cut the panels? The cabinet shops have all that stuff and could do that with there eyes closed. Then you would...
    20 replies | 1179 view(s)
  • RichardG's Avatar
    03-02-2014, 08:38 PM
    RichardG replied to a thread Overstrike Protection in General
    If you still have the piece get some 3m 5200 caulk /sealent and use that stuff to glue it . Use the fast dry stuff it is really strong and tuff stuff...
    18 replies | 1128 view(s)
  • RichardG's Avatar
    03-01-2014, 01:29 PM
    RichardG replied to a thread O.T. Dodco trailer wheels in General
    I am almost positive that the guy I loaned it to backed it over a curb at a angle witch caused the problem. When I am through it will look more like...
    21 replies | 1100 view(s)
  • RichardG's Avatar
    03-01-2014, 12:44 AM
    RichardG replied to a thread O.T. Dodco trailer wheels in General
    They are mobile home axles I have had this trailer for about 8 years and have put on new tires for highway use. I plan to bolt them up and make sure...
    21 replies | 1100 view(s)
  • RichardG's Avatar
    02-28-2014, 07:57 PM
    I have a nice heavy duty trailer with a dodco trailer axle . It is the one with the pinch washers holding the rim. I loaned it out a while back...
    21 replies | 1100 view(s)
  • RichardG's Avatar
    02-09-2014, 06:40 PM
    The last one I took apart had hard nails like concrete nails almost impossible to cut . If you come up with some thing that works post it. Thanks...
    30 replies | 2713 view(s)
  • RichardG's Avatar
    01-26-2014, 01:41 AM
    RichardG replied to a thread Question on anvils in General
    The lead I will be using will be from a old sail boat keel will cut a piece with the chain saw i don't think its pure lead ,not quite as soft . I...
    14 replies | 852 view(s)
  • RichardG's Avatar
    01-25-2014, 09:16 PM
    RichardG replied to a thread Question on anvils in General
    I have the rail anvil setting on about three feet of solid tree stump was hoping to ad a little more mass and lose a little ringing I don't use it a...
    14 replies | 852 view(s)
  • RichardG's Avatar
    01-25-2014, 07:06 PM
    RichardG started a thread Question on anvils in General
    I have a piece of old rail road rail it works ok but would setting it on a piece of lead about 2 inches thick make it work better? It would have more...
    14 replies | 852 view(s)
No More Results
About RichardG

Basic Information

Statistics


Total Posts
Total Posts
141
Posts Per Day
0.05
General Information
Last Activity
Yesterday 07:59 PM
Join Date
02-19-2007
Referrals
0