Search:

Type: Posts; User: ian radin

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    751

    May be I was not clear on die question. Of...

    May be I was not clear on die question. Of course, I am aware of taper, but some times that doesn't help. My question, has any body ever seen a die where the lable end is not away from the direction...
  2. Replies
    8
    Views
    751

    Two Questions

    On many threading dies both sides are tapered and I find it difficult to ascertain the leading edge. It seems on most the labeling, i.e. 1/4-20, is facing outwards, away from the direction of feed,...
  3. Replies
    57
    Views
    11,082

    spinning drill or work

    On one hand, it would not seem to matter, but..... So the question is; will a somewhat deep (say L/D around 10) drilled hole be less likely to wander when spinning work (lathe) or when spinning...
Results 1 to 3 of 3