Question for production machinists

[ronsmith100]

has anyone had experience runnig or setting up double disk grinders? A consulting gig awaits.

Ron

[Mark McGrath]

Better place to ask this question would be at www.practicalmachinist.com
regards,Mark.

[kap pullen]

You mean like Gardner Grinders?

No, I worked around themfor a couple of years. That was a production/incentive/operators job.

Those incentive guys would kill you for $.25. They were very possesive of their bonus.

They ground cast, and parted off piston ring blanks 24 hours a day.

Never saw a machinist run one.

It can't be that hard, it's only combination of some other machines.

You're a machine instructor so your bio says.

No sweat!

Kap

[jaybird]

Mark

Just curious why the Practical Machinist site a better place to ask this question than the Home Shop machinist?

J

[Milacron of PM]

Jay, the poster said "question for production machinists", and although some with that pedigree hang out here, alot more hang out at PM. This is the "home shop" machinist site after all, isn't it ?

[wierdscience]

<font face="Verdana, Arial" size="2">Originally posted by D. Thomas:
Jay, the poster said "question for production machinists", and although some with that pedigree hang out here, alot more hang out at PM. This is the "home shop" machinist site after all, isn't it ?</font>

Ya,all the button monkeys are over on that "Other site"