Results 1 to 2 of 2

Thread: Sharnoa Tiger 4 control

  1. 01-19-2003, 01:17 AM #1
    Steelfab
    Steelfab is offline Junior Member
    Join Date
    Jan 2003
    Posts
    2

    Question Sharnoa Tiger 4 control

    I recently purchased a sdc40 50 taper Sharnoa vericle milling machine. problem is...I cant get it to take a dnc program, the machine has a rs232 port retrofit...and i have the handshake software for sharnoa language....just cant figure out how to get the control to up=load programs...also have Sharnoa posts.....think i have everything needed...any help would be greatly appreciated.
    if ya cant find it anywhere.....make it!
    Reply With Quote Reply With Quote
  2. 01-28-2003, 09:39 PM #2
    Steelfab
    Steelfab is offline Junior Member
    Join Date
    Jan 2003
    Posts
    2

    Cool

    Through alot of research i resolved my problem, anyone else has this same problem , there is a complex sequence of exchanging software into the control......thanx anyways.....SteelFab
    if ya cant find it anywhere.....make it!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules