Lathe bench

[Evan]

There has been some discussion from time to time about lathe benches. I am a firm believer that if you don't have a good support for the lathe then you are wasting your time. I have described my bench before but I haven't shown it. This bench is about as solid as it gets. The top and bottom parts of the bench top are 3/4" high density particle board (HDPB) laminated to a frame of 2"x4" wood spaced on 8" centers, glued and screwed, covered with galvanized steel. The back and sides are the same but without an inner layer of HDPB. The scrap shelf gives additional rigidity. A very handy tool drawer resides just under the bench top on glides. You may also note the channel iron the lathe is bolted to. Please ignore the packrattyness of the shop, it's a disease...

Oh, I ran out of stain 22 years ago...





[This message has been edited by Evan (edited 10-29-2003).]

[Paul Gauthier]

Ditto on pictures. But again it sounds quite sturdy.

------------------
Paul G.

[abn]

Nice work as always...the channel mount is nice to isolate the lathe from the wood during humidity change. Thought I'd comment on the photo, the lighting makes it look like you have gold plated ways!! Surely a sign of Providence.

[pgmrdan]

.

[This message has been edited by pgmrdan (edited 03-08-2004).]

[Evan]

Dan,

Funny thing, my next project doesn't really need any milling... BUT, I'll try to find some reason to use it anyway

[BFHAMR]

Evan,

Looks good, but I think you are too hard on yourself about the packrattyness. You have a long way to go to compete with some of us.

Dan

[Evan]

BF(Dan),

We been through all that already I still haven't shown what's in my sheds...

[pgmrdan]

.

[This message has been edited by pgmrdan (edited 03-08-2004).]

[Evan]

Uh huh.

[pgmrdan]

.

[This message has been edited by pgmrdan (edited 03-08-2004).]