Two Jaw Vice?
I need to build a small vice that will center the workpiece when tightened.
The maximum opening just over 2".
I cannot figure out how to do it simply. I have figured out ways to do it but it becomes to bulky.
This will be used as part of an attachment for my belt grinder to round the ends of material. The vice will sit on a cross slide type of mechanism in order to feed the workpiece to the belt as the rounding process progresses.
The reason is so I don't have to drill a hole in every piece I want to round the end. The pivot will be under the workpiece.
How to become a millionaire: Start out with 10 million and take up machining as a hobby!