Atlas Mill question

[bnrg]

Hi,
I am rebuilding an Atlas MF-C horizontal mill but it is missing the motor and countershaft pulleys. If anyone has one of these mills can you measure the diameters for me? They appear from pictures to have two steps.

Thanks,
Bob

[hal9000]

I'm going to try to find time to put the motor back on my recently acquired MF model this weekend. I'll measure the pulleys when I do (assuming I actually get around to doing it!)

[uncle pete]

Bob,
Here's the dimensions from my MFB.
6.435" Groove Depth .580"
4.438" GD .560"
3.218" GD .390"
2.366" GD .400"

These should be close enough for what you need.

Pete

[hal9000]

Bob,
If you're looking for pulleys, there seem to be several to choose from on ebay right now.

[bnrg]

Thanks for your help. I will check out the ebay auctions.
Bob

[flylo]

I have several Original Atlas motors If needed.