Just watched the milling machine locating video. Excellent as usual, and it's the first time I have seen someone demonstrate the use of the center finder (pointy end of some edge finders). I remember searching for it a while back, and there was a thread on PM about it. Half the posters insisted that it had no practical use, and the other half argued about how it should be used. Funny, they rarely argue over there
If you're still looking for suggestions, I would like to see a face milling video. Choosing the right width cutter, best location to enter the cut, step-over, HSS vs. carbide, etc.
Great videos Stuart.
I was only going to watch one but you made me spend 45 minutes I didn't have!
My Dad always said, "If you want people to do things for you on the farm, you have to buy a machine they can sit on that does most of the work."