Announcement

Collapse
No announcement yet.

OK, new MW magazine, what's the picture?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • OK, new MW magazine, what's the picture?

    Inside the magazine, opposite the table of caontents, there are usually pictures from the articles......

    This month, the lower one seems not to be from anywhere.... It shows a mill or DP chuck, holding something that appears to be let down into an engine cylinder head. I flipped thru all the articles, and didn't see the picture....

    If I had to guess, it would be that it is from the "mill slowing" article, but didn't get printed. Against that is the fact that it is in color, and most all of those are in B&W.

    Troubling doings in the magazine..... must be some sort of secret code for launching a maniple of mysterious metal-munching malefactors, who are now supposed to "head" somewhere and give something a severe reaming out.... obviously they are supposed to gather at Chuck's location.... but one must have the key.....and it must involve binding them to adhere to the demands of some serious vice..... or maybe at this time they will simply be drilled in some activity..... Perhaps the rest of the clues are contained seprately, in the quill memorandum, and we can look at the picture until it is printed blue on our faces without pressing any further meaning from it.
    CNC machines only go through the motions.

    Ideas expressed may be mine, or from anyone else in the universe.
    Not responsible for clerical errors. Or those made by lay people either.
    Number formats and units may be chosen at random depending on what day it is.
    I reserve the right to use a number system with any integer base without prior notice.
    Generalizations are understood to be "often" true, but not true in every case.

  • #2
    http://bbs.homeshopmachinist.net//Fo...ML/012898.html
    Location: North Central Texas

    Comment


    • #3

      I actually DID look thru the posts before posting.......didn't see that one, it was too far back, my mag only just came...... I forgot I am in the back of the bus......


      Ar, I looked..... it is 5 pages back, almost 2 weeks..... no I do NOT feel bad about missing that question.....



      [This message has been edited by J Tiers (edited 08-12-2005).]
      CNC machines only go through the motions.

      Ideas expressed may be mine, or from anyone else in the universe.
      Not responsible for clerical errors. Or those made by lay people either.
      Number formats and units may be chosen at random depending on what day it is.
      I reserve the right to use a number system with any integer base without prior notice.
      Generalizations are understood to be "often" true, but not true in every case.

      Comment

      Working...
      X