Announcement

Collapse
No announcement yet.

Halfnuts - Identify?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Halfnuts - Identify?

    Anyone know what these halfnuts might go to? They are Large!




  • #2
    Hmm, I dont know, IOWolf seams a half nut short

    Comment


    • #3
      Oh no, here we go.
      Civil engineers build targets, Mechanical engineers build weapons.

      Comment


      • #4
        What size is the lead screw that it would fit? What are the casting marks? My Nebel lathe has large half nuts and very large half nut operating lever.

        Frank

        [This message has been edited by PolskiFran (edited 08-19-2005).]

        Comment


        • #5
          I think these are 1" 6tpi but I'm not for sure. I'll have to get the dimensions and marks tomorrow. What casting marks there are, are shown in the first picture. I just can't make them out now either. They're NOS but don't fit anything I have.

          Comment


          • #6
            I think they are South Bend, most likely a 16".
            Harry

            Comment

            Working...
            X