Announcement

Collapse
No announcement yet.

Halfnuts - Identify?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • beckley23
    replied
    I think they are South Bend, most likely a 16".
    Harry

    Leave a comment:


  • CCWKen
    replied
    I think these are 1" 6tpi but I'm not for sure. I'll have to get the dimensions and marks tomorrow. What casting marks there are, are shown in the first picture. I just can't make them out now either. They're NOS but don't fit anything I have.

    Leave a comment:


  • PolskiFran
    replied
    What size is the lead screw that it would fit? What are the casting marks? My Nebel lathe has large half nuts and very large half nut operating lever.

    Frank

    [This message has been edited by PolskiFran (edited 08-19-2005).]

    Leave a comment:


  • rockrat
    replied
    Oh no, here we go.

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Hmm, I dont know, IOWolf seams a half nut short

    Leave a comment:


  • CCWKen
    started a topic Halfnuts - Identify?

    Halfnuts - Identify?

    Anyone know what these halfnuts might go to? They are Large!



Working...
X