Announcement

Collapse
No announcement yet.

Need suggestions for mill vise for Grizzly mini-twins.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need suggestions for mill vise for Grizzly mini-twins.

    .

    [This message has been edited by pgmrdan (edited 03-19-2004).]

  • #2
    When I first bought my Grizzley G1006 drill/mill (with the long table), I didn't have a lot of cash remaining for extras. I purchased a G5751 4 inch drill press vise and hoped for the best. It was a great (and lucky) choice. It has 1/2 inch slots at the edge so it can be bolted down to to the table. This particular vise has a nice wide horizontal surface to rest the work on (or supports for the work). It has given me good service and didn't break the bank. Their "improved" drill press vise is not as useful because of the wide gap in the middle. For the price and the service that it has given me, I'd buy it again in a minute.

    [This message has been edited by fixxit (edited 02-03-2003).]
    457863656C73696F7220212000

    Comment

    Working...
    X