Announcement

Collapse
No announcement yet.

The right tool for the job? HF metal bender

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Well, my house was built by K&B homes for some one else, I purchased it without the original people ever moving in. Everything they did was on the cheap, so I would only expect the worse with my floor. I would be astonished if it was 5" thick, even 3"

    Comment


    • #32
      Well if the floor is that thin, just sledge hammer out a section and dig a square hole with a bit of flare-out at the bottom. Pour concrete and set some anchors.
      I seldom do anything within the scope of logical reason and calculated cost/benefit, etc- I'm following my passion-

      Comment

      Working...
      X