Drinking water safe materials?

[small.planes]

Delrin would work fine, but is somewhat sensitive to chlorine. Acetal would be a good choice, easy to work with and should last forever.

Delrin is Acetal. Delrin is a trade name for acetal homopolymer (iirc). Acetal is also available in copolymer.

I would go with brass or stainless steel, mostly depending on what was on the shelf…

Dave

[Tom S]

I'm thinking of going with C693 brass: https://www.onlinemetals.com/en/buy/brass-round-bar-693

Nothing wrong with that either.

[Tom S]

I read recently from here: https://www.copper.org/applications/...water_act.html

Does that change what you would recommend? or would you still be happy with 360 brass?

I'd still be happy with the 360. Its got around a 3% lead content and meets the standard that was acceptable for years, and if you applied the 'weighted average' system to you whole house plumbing would most likely easily stay under the .25% wetted area (I'm assuming this is just a small adapter, not a large section of brass pipe or anything).

[stevejigsaw]

I'm thinking of going with C693 brass: https://www.onlinemetals.com/en/buy/brass-round-bar-693

[stevejigsaw]

According to their material standard you would be ok with any 200, 300, or 400 grade stainless or any copper, brass, or bronze with a lead content under 8% (so long as the only exposure is potable water).

I read recently from here: https://www.copper.org/applications/...water_act.html

The most recent change involves the 2011 Reduction of Lead in Drinking Water Act, which amended section 1417 of the SDWA and became effective on January 4, 2014. This new act made the following changes:

1. Redefine lead free in SDWA Section 1417(d) to:
   • lower the maximum lead content of the wetted surfaces of plumbing products such as pipes, pipe fittings, plumbing fittings and fixtures from 8.0% to a weighted average of 0.25%;

Does that change what you would recommend? or would you still be happy with 360 brass?

[Tom S]

NSF is the group that specifies materials for food usage in the US.

According to their material standard you would be ok with any 200, 300, or 400 grade stainless or any copper, brass, or bronze with a lead content under 8% (so long as the only exposure is potable water).

Plastics can be a bit trickier, since depending on the exact type of plastic there are concerns about chemicals leaching out. For that you would need to look at the FD&C act to check on a exact material, but generally I think you'd be safe with any pure nylon, abs, or pvc materials.

If it was me I'd probably just go with a 360 brass - it meets the criteria, easy to machine, will hold threads better than delrin in the long run, and is used by many manufacturers of similar fittings.

[Toolguy]

Delrin would work fine, but is somewhat sensitive to chlorine. Acetal would be a good choice, easy to work with and should last forever.

[Doozer]

Even leaded brass is fine.
The lead almost immediately forms lead oxide
and lead oxide is not harmful to humans.
The trouble with Flint Michigan is the treatment plant
put the wring chemicals in the water, and it dissolved
the lead oxide, and the pure lead was leaching off
and poisoning people.

-Doozer

[stevejigsaw]

Hi everyone,

I want to make an adapter for my faucet/tap so I can use my new table top water filter but I'm having a bit trouble deciding on the right stock to use due to lead content etc.

Would lead free brass be OK? or would something like Delrin be best?

Its a very simple project but I have spent hours researching materials and I'm still lacking definitive answers so any help would be appreciated.

Cheers,