Toggle switch housing for electric motors?

[flathead4]

Do asthetics matter in your application? You can buy a low profile box from your local Big Box and attach it to the peckerhead or other convenient spot.
That's what I did for this Delta grinder to replace a clunky controller the previous owner bolted to one of the legs

[genea]

Maybe something like this:

https://www.ebay.com/itm/26409572878...4AAOSwVAtcGwOF


Sorry, very similar to what flathead4 posted earlier.

[wierdscience]

Do asthetics matter in your application? You can buy a low profile box from your local Big Box and attach it to the peckerhead or other convenient spot.
That's what I did for this Delta grinder to replace a clunky controller the previous owner bolted to one of the legs

I would use that if I could, but these motors are 48 frame resilient mount motors, so the wiring connection happens under a Kidney shaped sheetmetal cover on the end of the motor. There isn't much room there for a 2x4 formed box. Plus this is a prototype for a tool I may bring back from extinction, so it would be nice to have the switch setup I'm looking for, because it was intended to give the mfg a clean design.